Helpful Tips for Water Damage Repair in Scottsdale, AZ

When water seeps into your home, it can cause a lot of damage, especially if it sits for a while without being dried up. If you are able to act quickly enough, you can minimize this potential damage and save some of your possessions.

You should never underestimate the ability of floodwater to cause damage. Even if there’s just an inch of water in your basement, or even if areas are just slightly damp, these spots can quickly become breeding grounds for mold. Mold can cause severe structural damage to walls and floors, ruin your flooring and furniture and cause poor indoor air quality, which could lead to respiratory problems in people who are constantly exposed to its spores.

With this in mind, here are some steps for water damage repair in Scottsdale, AZ that you should take whenever you are dealing with significant water damage or flooding in your home:

• Remove electronics and disconnect power: This should be the very first step you take. The quicker you get electronic items out of the way, the more likely it is you’ll save them. Shutting off the power is also extremely important; if water rises above outlets, it could short out your electrical systems.
• Move furniture or carpet: After checking the electrical outlets and electronics, move any furniture you have, either putting it in higher rooms or putting it up on blocks above the floodwaters. Pull up any carpets in the area; there’s a chance you’ll be able to save these carpets if you get them properly cleaned and disinfected. However, there’s also a chance it’ll shrink. Typically you will not be able to save the under-padding, as it will absorb a lot of the floodwater. This you will have to replace.
• Get rid of water: There are several methods you can use to get rid of the water that’s seeping into your home. If you’re worried about loose wires or have lost power, you’ll probably have to use mops, buckets, towels and sponges. So long as the sewers are not backed up, you can pour this water down a drain or outside. You can also use a wet vacuum; just make sure you plug it into an outlet that is far away from any water that’s built up in your basement. You might even be able to rent a sump pump.
• Dry out the area: After you’ve gotten rid of the water, you should use fans and a dehumidifier to dry out the area as much as possible. If any drywall or other elements of a finished basement were affected, there’s a chance you’ll have to cut away those areas. The same goes for flooring and baseboard trim. This all depends on how much water got in and how quickly you were able to remove it.
• Disinfect: After the area is dry, get a high quality disinfectant and wipe down any surfaces that came into contact with the water, including walls, floors and non-upholstered furniture.
• Continue running dehumidifiers and apply anti-mold products: Even after you’ve gotten the area dried and disinfected, you should take other actions to prevent mold from setting in. Keep running dehumidifiers and apply anti-mold products.

For more information about water damage repair in Scottsdale, AZ, contact us today at Phoenix Building Services, LLC.

Categorised in: Water Damage Repair

This post was written by Writer